Sciweavers

2497 search results - page 298 / 500
» Requirements for models of achievable routing
Sort
View
JNW
2008
177views more  JNW 2008»
15 years 6 months ago
Design and Evaluation of a Novel HIP-Based Network Mobility Protocol
The rapid growth of IP-based mobile telecommunication technologies in the past few years has revealed situations where not only a single node but an entire network moves and change...
Szabolcs Nováczki, László Bok...
ICCAD
2009
IEEE
151views Hardware» more  ICCAD 2009»
15 years 4 months ago
Timing yield-aware color reassignment and detailed placement perturbation for double patterning lithography
Double patterning lithography (DPL) is a likely resolution enhancement technique for IC production in 32nm and below technology nodes. However, DPL gives rise to two independent, ...
Mohit Gupta, Kwangok Jeong, Andrew B. Kahng
ICCAD
2003
IEEE
145views Hardware» more  ICCAD 2003»
16 years 3 months ago
Manufacturing-Aware Physical Design
Ultra-deep submicron manufacturability impacts physical design (PD) through complex layout rules and large guardbands for process variability; this creates new requirements for ne...
Puneet Gupta, Andrew B. Kahng
ESORICS
2008
Springer
15 years 8 months ago
Symmetric Key Approaches to Securing BGP - A Little Bit Trust Is Enough
The Border Gateway Protocol (BGP) is the de facto inter-domain routing protocol that connects autonomous systems (ASes). Despite its importance for the Internet infrastructure, BGP...
Bezawada Bruhadeshwar, Sandeep S. Kulkarni, Alex X...
TIFS
2008
149views more  TIFS 2008»
15 years 6 months ago
Secure Cooperation in Autonomous Mobile Ad-Hoc Networks Under Noise and Imperfect Monitoring: A Game-Theoretic Approach
In autonomous mobile ad-hoc networks, one major challenge is to stimulate cooperation among selfish nodes, especially when some nodes may be malicious. In this paper, we address co...
Wei Yu, K. J. Ray Liu